2013-2016 For A4/S4 B8.5 RS4 Style Front Bumper With Fog Light Grille Honeycomb Grille

• Transformation Path: B8.5 RS4 front clip conversion for facelifted A4 and S4 sedan platforms
• Manufacturing Material: High-melt-flow Polypropylene with a Class-A surface finish straight from the mold cavity
• Components List: Main bumper fascia, three honeycomb grille sections (center, left fog, right fog), lower valance trim
• Applies To: 2013–2016 Audi A4 and S4 (B8.5 facelift, sedan)
• Sensor Setup: PDC ports with integrated wire-routing channels on the back side of the shell for clean harness management

Product Overview

The B8.5 A4 and S4 received a meaningful exterior refresh, but the bumper remained visually conservative — narrow grille, small side intakes, no lower aggression. This RS4 conversion rectifies all three. The grille expands outward and downward, the side vents open into full-height trapezoidal intakes, and the lower valance drops lower with a sharper leading edge. The honeycomb pattern is consistent across all three grille zones, and the mesh density matches the RS4's factory specification.

Key Features & Build Quality

• Class-A Mold Surface: The tool cavity is polished to a mirror finish, so the raw PP bumper emerges with a surface smooth enough for direct primer application — no filling or heavy blocking required.
• Triple-Zone Consistent Mesh: Center, left, and right grilles all share identical hex-cell dimensions, pitch, and gloss level for a perfectly unified front graphic.
• Full-Height Side Vents: Unlike some conversions that only open the upper half, these side intakes are unobstructed from top to bottom for maximum visual depth.
• Wire-Routing Channels: Molded guide channels on the inner surface keep sensor harnesses tidy and prevent wires from drooping into visible areas behind the mesh.

Vehicle Fitment & Compatibility

• Designed for 2013, 2014, 2015, and 2016 Audi A4 and S4 (B8.5 facelift, sedan only).
• Avant/wagon compatibility not confirmed; bumper mounting points may differ at the lower undertray.

Body Shop & Paint Prep Notes

• The Class-A surface means you can go straight to 800-grit scuffing after degreasing — no need for heavy primer-filler or block-sanding of mold marks.
• Keep the wire-routing channels clear of paint buildup; a thin layer is fine, but heavy overspray in the channels can make harness routing difficult later.

💬 If you are unsure about product compatibility, please send your Vehicle Identification Number (VIN) or front and rear photos of your vehicle to us for verification.